This little project is a Winged Emblem Collins KWM-2A that came off Ebay years ago.  It went into the retirement project pile.  Now that I am getting close to retirement I dragged it out and looked over what was needed.  These pictures are after an extensive cleaning and inspection.  The filter is missing.  The power switch has been wired around.  There is some rust on some of the steel parts, apparently it was not stored in a -not so dry- location at some point.  Eventually I will have the pictures of the finished restoration on the web site.  Jack WB8BFS has volunteered his expertise to help finish out this project.

Front view with the front panel removed

Rear view

Rear RCA's on the RF side

Rear RCA's on the Receiver side

Side view

IF side view

Side view of crystal bank

Looking down on the meter switch

Left panel at the power switch

Another view of the power switch and filter bracket

Top crystal bank and power switch

Top control panel

Edge of top control panel

The LMO (actually PTO - a Collins invention)

The 6146 sockets in the RF cage

RF cage pi-net coil and loading capacitor

RF cage supressors and tune capacitor

Another view of the pi-net section and band switch

Inside the RF cage

Bottom of the RF cage

Close up view of the RF output bottom section

Rear of preselector

Middle of preselector

Front of preselector

Bottom front of preselector

Another view of the preselector and band switch

Front of band switch near the main crystal deck

Under chassis view of preselector and band switch

Old style open frame relays

USB / LSB carrier crystals

Is this where you set your carrier point ??

Crystal selector wafer section of band switch

Band switch linkage

Audio out transformer and AGC section

A bottom view

IF section

IF section

Another bottom view

Serial number tag is in poor condition